Skip to content

IRATA and SPRAT certified rope access teams, working from our Ontario base across Canada.

info@dipenzeintegratedcanada.com

Industrial inspection and NDT

Asset integrity data gathered from rope, drone and confined space entry, so inspection happens without the scaffold bill and without shutting the asset down.

Inspection methods

The method follows the question the asset owner is asking. Most programmes combine a close visual pass with targeted readings at the locations that pass raises.

Close visual inspection

Hands on survey of welds, coatings, fixings and corrosion at arm's length, photographed and located so findings can be revisited.

Ultrasonic thickness testing

Wall loss readings on shells, pipework and structural sections at fixed grid points, trended against previous campaigns.

Surface crack detection

Magnetic particle and dye penetrant testing of welds and connections, carried out in position rather than after removal.

Drone and remote visual survey

Aerial survey to scope a structure quickly and target where technicians need to go, with thermal imaging where moisture or heat loss is the question.

Tank, stack and silo surveys

External and internal condition assessment of storage tanks, chimneys, flare stacks and silos, including liner and coating evaluation.

Structures and lifting equipment

Bridge, gantry, tower and crane inspection, plus statutory examination of lifting equipment and accessories across a site.

Asset integrity, not just a report

An inspection that only produces a PDF has done half the job. Because our technicians are tradespeople as well as inspectors, small defects are often closed out on the same mobilisation.

Located findings

Every defect tied to an elevation, level and grid reference, so the next crew finds it without a guided tour.

Repair on the same visit

Minor coating, sealant and fixing defects corrected while the team is already rigged, with the repair recorded alongside the finding.

Trended over time

Readings taken at the same points each campaign, so corrosion rates and remaining life are a calculation rather than an opinion.

Tell us about the elevation.

Photographs, drawings or an engineer's report are enough to start. We come back with the access method, the scope and a schedule.